Anchor Fasteners

Metric / inch size available

Stainless steel sleeve anchors and special length sleeve anchors available

The sleeve anchors allow it to anchor into concrete, brick and block. Sleeve anchors work when you insert it into a predrilled hole in the base material and then turn the nut to pull the working end of the sleeve anchor up through the sleeve. The anchor is then expanded and anchored securely in the concrete, brick or block. The anchors are available in zinc plated and stainless steel. Sleeve anchors come fully assembled and ready to use.

Other Used Names

Sleeve thunderbolts,

bolt sleeve anchors

, masonry anchors

Hex Bolt Hex Bolt with Plastic Hex Flange Nut Flat Head Slotted

C-Hook O-Hook Flat Nut Inch Size

Heavy duty shield anchor 4 pcs / 3 pcs / 2 pcs shells used to dirt & moisture is appreciated.

High retaining power & can be removed easily.

When tightening the nut or screw the conical section is pulled into the anchor shells expanding it & wedging it inside the anchor base

.

Shield Anchor Body Only Shield Anchors with Hex Bolt Sield Anchors with Eye Bolt and Hook Bolt Shield Anchors with Projecting Bolt Using a diameter which equals the anchor diameter,drill hole to min embedment Drive the sten till washer is flush with material to be fastened Expand anchor by tightening nut or head 3 to 5 turn

Metric / inch size available
Stainless steel heavy duty shield anchor and special length available

It's ideal to be used for building materials, withthickness less than 6mm, and fasten the window curtan and mirror frame, wire plumbing, soap and towel holder,and wallshelf, etc.

It is inserted into the hole and become narrow. With the turning, nylon part will be separate and become flat in the hole.

Installation of Nylon Ceiling Anchor

The wedge anchors (also called heavy duty concrete anchor) are used to anchor fixtures on to concrete. The wedge anchors are inserted into a predrilled hole and then expanded, causing them to wedge securely in the concrete. The concrete wedge anchor is available in zinc plate steel, hot-dipped galvanized and stainless steel.

Other Used Names

Metal hit anchors are inserted into a pre-drilled hole in concrete, brick or block. They are set when the nail is driven into the anchor, creating expansion.

Designed for light-duty concrete, the metal hit anchors are made to withstand unusual toughness. Made of carbon steel, the pin expander has been properly heat-treated and heavily zinc plated so that the metal hit anchor has maximum corrosion resistance.

Metal Hit Anchor Heavy Duty Type A

Metal Hit Anchor Heavy Duty Type B

Metal Hit Anchors Size Thread Length (mm) Drill Dia. (mm) Pull out Load (Kgs) M6X45 15 6.4 475 M6X60 20 6.4 M8X50 20 8.5 705 M8X70 25 8.5 M10X50 20 10.5 1180 M10X60 25 10.5 M10X80 25 10.5 M10X90 30 10.5 M10X100 30 10.5 M10X120 30 10.5 M12X60 20 12.7 1850 M12X70 25 12.7 M12X90 30 12.7 M12X100 40 12.7 M12X120 50 12.7 M16X100 40 17.0 3300 M16X120 40 17.0 M16X150 50 17.0 M20X130 50 21.5 4600 M20X150 50 21.5 M20X190 50 21.5

It's ideal to be used for building materials, even thin. It endures temperature (-40--+80), rust, corrosion, aging, and chemical afftect. Meanwhile good at electric insulation, tensibility, and high pressure. The structure designed with gear can prevent itself sliding in the hole.